Rain Chamber

Bay Area Test Equipment Inc is one of the leading rain chamber manufacturers and suppliers,Website:http://www.bacldesign.net, welcome to buy and wholesale cheap and best rain test chambers from us. Rain Chamber Rain Chamber are widely used to test anti-rain and waterproof performance for auto parts, household appliances and other products  Specification & Technical data Grade IPX1 Test name Vertical water dripping test Sample position a.Place sample on the rotation table with adjustable 1-17r/min             b.Distance between the top side of the sample and the spout less than 200mm Test condition The water dripping rate is 1+0.5 mm/min,spacing between dripping hole 20mm Test time 10 min Grade IPX2 Test name 15° water dripping test Sample position a.15 angle between one side of the sample and the vertical line         b.Distance between the top side of the sample and the spout less than 200mm.   c.Turn to test another side  and repeat it 4 times. Test condition the water dripping rate is 3+0.5 mm/min,spacing between dripping hole 20mm Test time 4×2.5 min(total 10 min) Grade IPX3 Test name Water pouring test Test method Oscillated water pouring test device Sample placement a.selec pendulum tubes (Φ16mm) with appropriate radius(0.4/0.6m/0.2/0.8/1.0/1.2/1.4/1.6m) and make the sample table height equals to the diameter of pendulum tubes . b.Place sample on the table(does not move) and dstance between the top side of the sample and the spout less than 200mm. Test condition Water flow rate is calculated on the basis of the number of the spray hole of the pendulum tubes, each hole equals to 0.07 L/min.During testing, the spray hole spray water to the sample on both side of the midpoint of the pendulum tubes with 60°swinging, and the sample is placed in the center of the semicircle of tubes. The tube swings 60°respectively back and forth, total 120. It takes about 4s to swing (2×120°) once a time. Test time 10 min Grade IPX4 Test name Water splashing test Test method Oscillated water pouring test device Sample placement a.selec pendulum tubes (Φ16mm) with appropriate radius(0.4/0.6m/0.2/0.8/1.0/1.2/1.4/1.6m) and make the sample table height equals to the diameter of pendulum tubes . b.Place sample on the table(does not move) and dstance between the top side of the sample and the spout less than 200mm. Test condition Water flow rate is calculated on the basis of the number of the spray hole of the pendulum tubes, each hole equals to 0.07 L/min.During testing, the spray hole spray water to the sample on both side of the midpoint of the pendulum tubes with 90°swinging, and the sample is placed in the center of the semicircle of tubes. The tube swings 180°respectively，total 360°.It takes about 12s to swing (2×360°) once a time. Test time 10 min Grade IPX5 Test name Water spraying test Test device The spout diameter of the nozzle is 6.3mm； Test condition Distance between the top side of sample and the spout is 2.5~3m and the water flow rate is 12.5 L/min (750 L/h)； Test time The time is calculated on the basis of the surface area of the sample，each square meter equals to 1min(exinclude installation area), the minimum time is 3 min Grade IPX6 Test name Intensive water spraying test Test device The spout diameter of the nozzle is 12.5mm Test condition Distance between the top side of sample and the spout is 2.5~3m and the water flow rate is 100 L/min (6000L/h)； Test time The time is calculated on the basis of the surface area of the sample，each square meter equals to 1min(exclude installation area), the minimum time is 3 min