Stepper Drive DH422

Equipped with professional stepper drive DH422 factory,Website:http://www.hybridservo.com, Shenzhen ECON Technology Co.,Ltd is a leading stepper drive DH422 manufacturer and supplier.Ultra low noise , high stability and smoothness digital stepper driveIntroductionOverviewDH422 is the new generation high performance fully digital stepper drive which base on 32bit DSP with a advanced algorithm .the power supply range is DC18~36V. it can drive frame 42mm 2 phase stepper motor .Ultra low noise and high smoothness at middle/low speed ,and high torque at high speed, which can be applied to different speed control applications. adopt smooth and accurate sinusoidal current vector control technology ,which make motor low heat .Features●new generation 32bit DSP ●good smoothness ,low noise ,low heat ●build-in micro step setting ●build-in current setting ●the standstill current can be set to 50%●opto-isolated differential pulse input ●the response frequency is up to 100KHz●over voltage , under voltage, over current protectionApplications It can be used in various kinds of machines ,such as dispenser machine. floating machine3D printer, labelling machine, medical machine, laser cut machine, and so on ,its unique features make it an ideal solution for the applications which require low noise ,low vibration, low heat and high precision  Mounting dimension（unit：mm）FunctionCurrent Setting Peak current A)RMS current (A)SW1SW2SW30.30.2ONONON0.50.4OFFONON0.70.5ONOFFON1.00.7OFFOFFON1.30.9ONONOFF1.61.1OFFONOFF1.91.4ONOFFOFF2.21.6OFFOFFOFFStandstill Current Setting SW4：OFF=Half CurrentON=Full CurrentMicrostep Setting Pul/revSW5SW6200ONON1600OFFON3200ONOFF6400OFFOFFInterface Description NameFunctionDescriptionPWRPower lightWhen power on ,the green light is on  ALARMOver current/under voltage/over voltage displaying lightIf the drive Over current/under voltage/over voltage, the red light is on PUPulse inputPulse signal: In single pulse (pulse/direction) mode, this input represents pulse signal, each falling edge active; 4-5V for High -level, 0-0.5V for low-levelDRDirection input DIR signal: In single-pulse mode, this signal has low/high voltage levels, representing two directions of motor rotation;+5VPulse input VCCOpto-coupler power supply, and the typical voltage is +5V. Series connect resistors (at the PU, DR, MF terminals) for current-limiting when +12V or+24V used.(should connect 1k resistor for  +12V,2k for +24V)MFEnable signalEnable signal: This signal is used for enabling/disabling driver. High level for enabling the driver and low level for disabling the driver. Usually left UNCONNECTED (ENABLED).V-Power input COM DC18-36VV+Power input VCCA+,A-Motor A phaseConnect to   Motor A phaseB+,B-Motor B phaseConnect to   Motor B phase！NoteA: Connect power supply rightly ,can’t exceed 36VDC B: If the control signal (PU, DR,MF  ) is over 5V ,please connect resistors (at the PU, DR, MF terminals) for current-limiting.C: If the alarm light is on ,please check it after power off    a :the power supply range is 18V—36VDC or not ? b:is there any short on motor wire or others?