N male to SMA male RF Coaxial Connector

RF coaxial connectors is an element of the apparatus assembled or installed in cable , as transmission components or separation electrical connections. It belongs to the mechtronie product, which plays a role of bridge.

Our company provides all kinds of connectors in stock ,If you have special request, can provide the parameters or to sample customization..OEM/ODM orders are welcome. Welcome to visit our website on http://www.lingqiang.com and letter from the advisory.

The SMA is one of the most commonly used RF/microwave connectors. It is intended for use on semi-rigid cables and in components which are connected infrequently. It takes the cable dielectric directly to the interface without air gaps. A few hundred interconnect cycles are possible if performed carefully. Care should be taken to join connectors straight-on. Prior to making a connection it is wise to inspect the female end to assure that the center socket is in good condition (fingers not bent or missing). 

A standard SMA connector is designed for interconnects to 12.4 GHz. Fortunately, a good SMA is usable to 18 GHz in most cables, and if well constructed with greater loss and lower return loss to 24 GHz. Most SMA connectors have higher reflection coefficients than other connectors available for use to 24 GHz because of the difficulty to anchor the dielectric support. Some manufacturers rate a special high quality version of an SMA that meets SMA standards as high as 26.5 GHz (The Johnson Field Replaceable SMA goes to 26.5 GHz, and the M/A-Com OSM extended frequency series goes to 27 GHz). Because an SMA with such quality can be repeatably manufactured, you will often see test equipment and components rated to exactly 26.5 GHz with SMA connectors as the primary interconnect. "SMA" connectors rated for frequencies higher than 27 GHz are really following other standards and are made to be compatible with the SMA geometries to allow mating with SMA. So called "precision SMA" connectors are available with a variety of designators (e. g.,  3.5 & 2.92 mm). When two SMA compatible connectors of different ratings are coupled, it is very likely that the performance of the lesser connector will prevail. 

Be advised that when mating a male SMA to a female "Precision SMA", to be sure that the SMA male is of professional manufacture, and to insert the male straight-on. If there is any doubt, it is wise to invest in an SMA Connector Gauge, and gauge the SMA male prior to mating. This advice does not apply to the connection of an SMA female to a 3.5 or 2.9 male. Such connections do need to be made with care and straight-on.

 

The Type N 50 ohm connector uses an internal gasket to seal out the environment, and is hand tightened. There is an air gap between center and outer conductor. In the 1960s, improvements pushed performance to 12 GHz and later, mode-free, to 18 GHz. Hewlett Packard, Kings, Amphenol, and others offer some products with slotless type-N outer conductors for improved performance to 18 GHz. Type-N connectors follow the military standard MIL-C-39012. Even the best specialized type-N connectors will begin to mode around 20 GHz, producing unpredictable results if used at that frequency or higher. A 75 ohm version, with a reduced center pin is available and in wide use by the cable-TV industry.