Click image to view original image
6.2.11 After stopping the machine to clean and keep clean, as required equipment maintenance item list of the affected items are checked and maintained and recorded. 6.3 6.3.1 Check the foil pads into the cover cap aluminum foil gasket automatic plugging machines, punch mounted fixtures, clean the conveyor belt should be intact; 6.3.2 check the machine safety devices, pressure and other action should be set for production requirements; 6.3.3 open the valve, the cap material into vibration transfer hopper, through an automated machine and plugging the vibration transmitting plate power; 6.3.4 will start in the automatic mode, to start the cycle into the pad; 6.3.5 production technology press "process inspection guide book "examines the product, commissioning and test products in line with standards, produced by the technical staff of 10 to 20 randomly selected products and the" product first article inspection reports, "fill in the debugging product information and sent IPQC. 6.3.6 trial products by IPQC inspection confirmed qualified before mass production, when the trial product was not qualified to confirm IPQC inspection, IPQC notification by technical staff continue to adjust until after the product before mass production of the first pieces to confirm compliance. 6.3.7 the production process to carefully observe the work of the machine, always check the quality of the case into the pad, abnormal timely treatment. 6.3.8 When you need to stop, press the stop switch or a touch screen machine's emergency stop switch, close the valve, then the vibration transmitting plate and the total power is turned off. 6.3.9 After stopping the machine to clean and keep clean, as required equipment maintenance item list of the affected items are checked and maintained and recorded.
IT security, health and labor protection technology security 8.1 technology 8.1.1 strictly enforce the provisions of the review with the feed inspection; 8.1.2 seriously implement the "management process management point of order"; 8.1.3 strictly enforce the "shift system"; 8.1.4 carefully cleared, Yan Geqing farm management press the "clearance management Rules" execution; 8.1.5 perform safety systems, strict management of production safety; 8.1.6 in case of equipment failure, must be repaired after use, can not be sick operation. 8.2 Process 8.2.1 improve health clean areas clean, press the "clean area maintenance and use of" execution; 8.2.2 manage the production of health workers, according to the "production staff health requirements" execution; 8.2.3 serious press "equipment, container cleaning the method of "cleaning equipment; 8.2.4 to strengthen the management of process water, process water monitoring according to strict" process water management and monitoring "implementation; 8.3 8.3.1 and pay attention to labor protection inspection of plastic injection molding machinery safety devices, can not arbitrarily removal, note the adjustment of various body parts do not enter the clamping area, so as not to hurt the adjustment is completed after several tests to ensure that the device functions well; 8.3.2 hollow plastic molding machine operation procedure shall not be placed in any part of the body together die area or action to ensure the safety of personnel; 8.3.3 process aluminum pad automatic plugging machine operation may not be part of the body down into the cylinder, and a rotating disk and other regional action to prevent fingers being crushed, to ensure the safety of personnel;
PBM Company is a Plastic Bottle Manufacturers, Plastic Water Bottle Manufacturers, Custom Plastic Water Bottle, Suppliers, HDPE Bottle Manufacturers, Plastic Bottle Cap Manufacturers
Website: www.plastic-bottle-manufacturers.com Plastic Bottle Manufacturers
