Products :
Introduction:
- 250 MHz IBM PowerPC Processor (350 Mips)
- Linux operating system
- a reader
- MPEG2 Hardware decoding
- DVB-S
- V.24/RS232 Interface
- 100Mbit Ethernet interface two-way
- 2 LED indicates
- unlimited number of TV / Radio channel list
- channel switching time
less than 1 second - full automatic service scan
- EPG (Electronic Program Guide)
- support DiSEqC
- multi-language
- digital bit stream out of the SPDI / F Interface (AC-3 / DTS)
- 1 Scart Scart (software control)
Technical parameters:
IF Input :950-2150 MHz
Signal Level - 65 dBm .... - 25 dBm
signal to noise ratio 12 dB maximum.
F female connector 75 ohm input impedance
AFC + / - 3 MHz
QPSK
input symbol rate range of 2 .... 45 M, SCPC / MCPC
correction 1 / 2, 2 / 3, 3 / 4, 5 / 6 7 / 8, automatic
video decoder:
MPEG-2 and MPEG-1 compatible
PAL G / 25 Hz video standard
the proportion of 4:3 / 16:9 (automatic )
audio decoder:
MPEG-1 & MPEG-2 Layer I / II
Stereo Frequency: 32 kHz, 44.1 kHz, 48 kHz, 16 kHz, 22.05 kHz, 24 kHz
analog output:
Output Level L / R 0,5 Vss 600 Ohm
THD> 60 dB (1 kHz)
isolation <-65 dB
digital output:
Output Level 0,5 Vss 75 Ohm
sampling digital filter 32 kHz, 44.1 kHz, 48 kHz
S/PDIF- optical output (AC3)
video parameters:
Enter FBAS 1 Vss + / - 0.3 dB on 75 Ohm
Teletext filter: ETS 300 472 standard
Scart Scart:
Output: FBAS, RGB, S-VHS
RS 232 interface:
bit rate 115,2 kBit / s max.
plug SUB-D-9
firmware upgrade
Ethernet: Ethernet port firmware upgrade
LNB power supply and polarity:
LNB Current 500mA max. short-circuit protection
LNB vertical polarization voltage <14V without load,> 11.5V (400mA)
LNB polarization voltage level <20V without load,> 17,3 V (400mA)
LNB to receive standby power-down
control:
DiSEqC 1.0/1.2 SAT position / SAT select
DiSEqC - Motor Control
Power consumption: <10W / 12V
Input voltage:
DC12V, AC + / - 15% of the
external power:
Input :110-240V AC / 50-60Hz / 0,6 A
Output: 12V = / 1A
Physical Specifications:
Temperature +15