Click image to view original image
Dry and damp granule will be uniformity and finishing.
Crushing and finishing granule of mass material.
Granulating for damp material.
Crush thermal sensitive material.
When operation, it will less heat and the powder dust is less.
The sieve of stator is made of stainless steel plate. It is not easy to damage.
The gap between crushing blade and sieve can be adjusted.
Can treat material that has adhesive property or is gum state, or heat and damp.
Follow the regulations of cGMP, PIC/S GMP, FDA
WIP System is available
Explosion Proof System is available: Suitable for organic solvent
Multi-safety Interlock System:
Stop operation when the cover is not closed properly
Stop operation when the air pressure is not sufficient for the seal
Separated compressed air routes design to meet the good air quality: the compressed air for air seal will pass through an air filter. For the cylinder, the compressed air will pass through lubricating oil to ensure the air quality and lubrication
Unique design of the air seal: This design can prevent powder access into the main seal and the chopper to prevent powder dropping
The clearance between impeller and the bottom of mixing bowl is only about 0.5~0.8 mm; therefore, high mixing efficiency can be achieved
Raw Material Grinding & De-agglomeration: It has the function of griding the lumps to smaller particle size. This can pre-process raw material to eliminate irregularities, therefore it will improve the mixing efficiency.
Size Reduction: Fix the oversize raw material t a smaller and uniform particle size.
Dry Granulation & Milling: Dry granulation can reduce granule/powder into desired range of particle size.
Wet Granulation & Milling: Wet material is reduced to a small and uniform particle size before drying. It produces small and uniform size fine powder form agglomerates that are produced by mixer. This is perfect for the dryer to take short time of achieving the uniform drying.
