titanium bar

  titanium  is a new type of metal ,the performance of titanium  is related to the content of carbon ,nitrogenmhydrogen and oxgyen .The pure titanium iodide impurity content less than 0.1%,bubt its low strentgh ,high performance plastic .99.5%pure titianium is :the demsity of (ρ)is 4.5g/cm3 ,the melting point of 172silicon titanium alloy wear-resisting flooring  5℃。coefficient of heat condivity is 15.24w/(m.k),tensile strength b is 539mpa .elongation is 25%,section shrinkage of PSI is 25%,elastic modulus e is 1.078*105Mpa ,hardness hb195.

Titanium Characteristic :high intensity,high thermal strength ,good  corrosion resistance ,good low temperature performance ,chemical active

Titanium  alloy density is about 4.5g/cm3,only 60%of steel ,the strength of pure titanium was close to ordinary steel strength ,high strength titanium alloy than many alloy structural  steel strength .Therefore  titaniuim alloyb strength (strength/density)is much larger than other metal structure materials,can be produced the unit  has high strength ,good rigidity .light quality zero components.The engine component ,the plane frame ,skin ,fasteners and landing gear  and so the use of titanium alloy .

1、Titanium rod specifications:
Titanium rod specifications:titanium   and titanium alloy bar light ,titanium alloy bar ,titanium profiled ,titanium square rod ,titanium shaft ,titanium stirring shaft ,titanium  screw.

The chemical composition of titanium alloy bar should be comsistent with provisions  of GB/3620.1,buyer the reinspection ,the chemical compositin of the devition should  be allowed meet the provisions of GB/T3620.2

2、Titanium rod prooduction :
National standard  of titanium :

TA1、TA2、TA3、TA7、TA9、TA10、TC4、TC4ELI、TC6、TC9、TC10、TC117、GR12、A221

3、Performance standards for titanium rods：

Titanium rods standards of GB, GB / 2965-2965, GB/T13810, Q/BS5331-91: American standard ASTM B348, ASTM F136, ASTM F67, AMS4928