high pure titanium bar

   Titanium  is  a   new type of metal ,the performance of titanium is related to the  content of carbon,nitrogen ,hydrogen and oxygen.The pure titanium iodide impurity content less than 0.1%,but its low strength ,high performance plastic .99.5%pure  titanium is :the density of (ρ)is 4.5g/cm3,the melting point of 172silicon titanium alloy wear-resisting flooring 5℃，coefficient  of heat condutivity is 15.24w/(m.k),tensile strength b is 539mpa .elongation is 25%,section shrinkage of PSI is 25%,elastic modulus e is 1.078*105MPa ,hardness  hb195.

Titanium Characterisitic :high intensity ,high thermal strength ,good corrosion resistance ,good low temperature  performance ,chemical active.


Titanium alloy  density is about 4.5g/cm3,only 60%of steel ,the strength of pure titanium was close to ordinary  steel strength ,high strength titanium alloythan many alloy structural steel strength .Therefirs  titanium alloy strength (strength /density )is much larger than other metal structure materials ,see  table  ,can be produced  the unit has high strength ,good rigidity ,light quality zero components.The engine component,the plane frame ,skin ,fasteners and landing fear and so the use of titanium alloy .

1、Titanium rod specifications:
Titanium  rod specifications；titanium  and titanium  alloy bar light ,titanium  alloy bar .titanium profiled ,titanium square shaft,titanium stirring shaft,titanium screw,
The chemical composition  of titanium alloyb bar should be consistent with provisions  of GB/3620.1,buyer the reinspection ,the chemical composition of the devition should  be allowed meet  the provisions of GB/T3620.2
2、Titanium rod production:
National  standard  of titanium :TA1,TA2,TA3,TA7,TA9,TA10,TC4,TC4ELI,TC6,TC9,TC10,TC117,GR12,A221.
3、Performance stadards for titianium rods；
Titanium rods standards of GB,GB/2965-2965,GB/T13810,Q/B5331-91;
American  standardASTM B348,ASTM F136,ASTMF67,AMS 4928.