Urine Specimen Drug Abuse Test Kit , 5 Panel Drug Test KitGold Colloidal With CE

MultiDrug of Abuse Rapid test,Urine Specimen, High Accuracy, Easily & Quick operation on spot, Gold colloidal method

 

 

 

 

Intended Use

 

 

The Multi-Drug Rapid Test Panel with Adulteration is a rapid chromatographic immunoassay for the detection of drugs and drug metabolites in urine at the following cut-off concentrations in urine:

 

 

Product	Cat No	Specimen	Sensitivity	Format	Kit Size
Drugs of Abuse (DOA) Tests
AMP	YD101S3	Urine	1000 ng/mL	3mm Strip	100T
	YD101C4			4mm Cassette	25T
BAR	YD201S3	Urine	300 ng/mL	3mm Strip	100T
	YD201C4			4mm Cassette	25T
BZO	YD301S3	Urine	300 ng/mL	3mm Strip	100T
	YD301C4			4mm Cassette	25T
COC	YD401S3	Urine	300 ng/mL	3mm Strip	100T
	YD401C4			4mm Cassette	25T
MOR(MOP)	YD501S3	Urine	300 ng/mL	3mm Strip	100T
	YD501C4			4mm Cassette	25T
MET	YD601SM	Urine	500 ng/mL	3mm Strip	100T
	YD601CM			4mm Cassette	25T
MTD	YD701S3	Urine	300 ng/mL	3mm Strip	100T
	YD701C4			4mm Cassette	25T
MDMA	YD801S3	Urine	500 ng/mL	3mm Strip	100T
	YD801C4			4mm Cassette	25T
THC	YD901S3	Urine	50 ng/mL	3mm Strip	100T
	YD901C4			4mm Cassette	25T
BUP	YD111S3	Urine	100 ng/mL	3mm Strip	100T
	YD111C4			4mm Cassette	25T
PCP	YD121S3	Urine	25 ng/mL	3mm Strip	100T
	YD121C4			4mm Cassette	25T
K2	YD131S3	Urine	200 ng/mL	3mm Strip	100T
	YD131C4			4mm Cassette	25T
OPI	YD141S3	Urine	2000 ng/mL	3mm Strip	100T
	YD141C4			4mm Cassette	25T
TCA	YD151S3	Urine	1000 ng/mL	3mm Strip	100T
	YD151C4			4mm Cassette	25T
KET	YD161S3	Urine	1000 ng/mL	3mm Strip	100T
	YD161C4			4mm Cassette	25T
TML	YD171S3	Urine	100 ng/mL	3mm Strip	100T
	YD171C4			4mm Cassette	25T
DOA 2-in-1	YD021C5	Urine	See Insert	2-in-1 Panel	25T
DOA 3-in-1	YD031C5	Urine	See Insert	3-in-1 Panel	25T
DOA 4-in-1	YD041C5	Urine	See Insert	4-in-1 Panel	25T
DOA 5-in-1	YD051C5	Urine	See Insert	5-in-1 Panel	25T
DOA 6-in-1	YD061C5	Urine	See Insert	6-in-1 Panel	25T
DOA 7-in-1	YD071C5	Urine	See Insert	7-in-1Panel	25T
DOA 8-in-1	YD081C5	Urine	See Insert	8-in-1Panel	25T
DOA 9-in-1	YD091C5	Urine	See Insert	9-in-1 Panel	25T
DOA 10-in-1	YD011C5	Urine	See Insert	10-in-1 Panel	25T
Alcohol	YD151C5	Saliva	See Insert	Strip	100T

 

 

 

DIRECTIONS FOR USE

 

 

Allow the test, urine specimen, and/or controls to reach room temperature

(15-30ºC) prior to testing.

Bring the pouch to room temperature before opening it. Remove the test panel from the sealed pouch and use it within one hour.

Remove the cap.

With the arrow pointing toward the urine specimen, immerse the test panel vertically in the urine specimen for at least 10 to 15 seconds. Immerse the dipstick to at least the level of the wavy lines, but not above the arrow on the test panel.

replac the cap and place the test panel on a non-absorbent flat surface.

Start the timer and wait for the colored line(s) to appear.

The result should be read at 5 minutes. Results may be stable up to 1 hour after test initiation.

 

 

 

INTERPRETATION OF RESULTS

 

(Please refer to the illustration above)

NEGATIVE:* A colored line appears in the Control region (C) and colored lines appears in the Test region (T). This negative result means that the concentrations in the urine sample are below the designated cut-off levels for a particular drug tested.

*NOTE: The shade of the colored lines(s) in the Test region (T) may vary. The result should be considered negative whenever there is even a faint line.

POSITIVE: A colored line appears in the Control region (C) and NO line appears in the Test region (T). The positive result means that the drug concentration in the urine sample is greater than the designated cut-off for a specific drug.

INVALID: No line appears in the Control region (C). Insufficient specimen volume or incorrect procedural techniques are the most likely reasons for Control line failure. Read the directions again and repeat the test with a new test card. If the result is still invalid, contact your manufacturer.

 

 

 

 

QUALITY CONTROL

 

A procedural control is included in the test. A line appearing in the control region

(C) is considered an internal procedural control. It confirms sufficient specimen volume, adequate membrane wicking and correct procedural technique.

Control standards are not supplied with this kit. However, it is recommended that positive and negative controls be tested as good laboratory practice to confirm the test procedure and to verify proper test performance.