Click image to view original image
TPV waterstop, also known as TPER waterstop, made of an alloy of rubber and plastic, acts as a fluid-tight diaphragm with excellent mechanical properties and higher chemical resistance than traditional waterstops. Without plasticizer, stabilizer or fillers, the TPV waterstops will not leech out when exposed to chemical fluids as hydrophilic waterstops.
HDPE Waterstop is used as a fluid-tight diaphragm, embedded in concrete, across and along the joint, for primary and secondary containment structures. Chemical Resistant Waterstops are ideally suited for fuel, oil, and other hydrocarbon
Features & benefits：
- Quality recycled thermoplastic elastomeric rubber materials - healthy and environmental friendly.
- Excellent resistance against chemical, ozone, oils, solvents, hydrocarbon and aggressive industrial liquids, etc.
- Not susceptible to ketones, esters, glycols, alcohol, and water solution of acids, salts and bases, etc.
- High resistance to long term temperature changing ranging from -78°F to 275°F.
- High elasticity.
- Superior weather and UV resistance
- Easy to butt-weld.
- low tension and compression set.
- Excellent dynamic fatigue resistance.
Installation:
Normally, the TPV waterstops are embedded into or installed along extend of joints for preventing water and chemical liquid leaking into the joints, which is the weak point in any concrete structure. As to the changes of directions, pre-fabricated products are needed for easy installation.
Application:
www.tpwaterstop.com
sales@tpwaterstop.com