Click image to view original image
| CE, RoHS | |
| DC12V/24V | |
| 7.2W/m | |
| Blue, Color Changing, Green, Red, RGB, White, Yellow | |
| 30leds/m | |
| DC | |
| 50000h |
Waterproof 5050 SMD RGB LED Strip Light 30leds/m IP65 Specifications: 1.SMD LED Strip Light 2.Type: Waterproof or non-waterproof 3.Warranty:2 years 4.5 years production experience 5.CE&RoHS 6. Model Number: BJ-5050-60ledstrip 7. Input Voltage: 12v 8. Color: White/R/Y/B/G/RGB 9. Power consumption: 7.2w/m 10. Angle: 120 degree 11. LED type: SMD5050 12. PVC width: 8mm 13. PVC length: 5m/reel 14. LED Qty:30leds/m 15. Life: 50,000h LED Strip Light De High Quality 5050 SMD RGB LED Strip Light is made of High Brightness SMD LED and Flexible PCB board. LEDs are evenly arranged on the surface of the PCB board. The flexible body is of a very high intensity with a large viewing angle.
It is commonly used in edge decoration which has unlimited uses as it can be cut and joined to create any angle and length.
LED Strip Light Features: With 3m adhesive tape on the back for easy installation.
Energy saving and environment protection.
Solid-state, high shock or vibration resistance.
Low power consumption, high intensity.
Wide viewing angle.
Available in various single and RGB colors.
LED Strip Light Application: Lights for hotel, disco, nightclub, coffee bar, shopping mall, theatre;
Home lights for kitchen, bedroom, furniture;
Lights for cove, archway, stairs, lift;
Backlight or edge lighting for signage;
Path and contour marking;
Decorative lights for holiday, event, show, exhibition.
LED Strip Light Assembly Information: 1. Solder connection should only be performed on designated solder pads (marked “ +/-”). During soldering, don’t exceed the maximum soldering time of 10 seconds and the maximum soldering temperature of 260 Celsius degrees.
2. The smallest unit (3 LEDs) can be removed by cutting with scissors between the designated solder pads.
3. The mounting of the strip is facilitated by means of the double-sided adhesive on the back-surface of the strip. Care must be taken to provide a clean and dry mounting surface, free of oils or silicone coatings as well as dirt place.
4. The mounting substrate must have sufficient structural integrity. Take care to completely remove the adhesive backing. Once the strip is appropriately positioned. Press on the strip with
5. The minimum bending radius is 2 cm. The strip may be bent over a smaller radius of the circuit board containing no electronic components and such bends should be made once and fixed in position to avoid cyclic fatigue.
LED Strip Light Safety Information: 1. The strip itself and all its components may not be mechanically stressed.
2. Assembly must not damage or destroy conducting paths on the circuit board.
3. Installation of LED strip (with power supplies) needs to be made with regard to all applicable electrical and safety standards. Only qualified personnel should be allowed to perform installations.
4. Correct electrical polarity needs to be observed. Wrong polarity may destroy the strip.
5. Parallel connection is highly recommended as safe electrical operation mode.
6. Serial connection is not recommended. Unbalanced voltage drop can cause hazardous overload and damage the strip.
7. Please ensure that the power supply is of adapters power to operate the total load.
8. When mounting on metallic or otherwise conductive surfaces, there needs to be an electrical isolation points between strip and the mounting surface.
9. Pay attention to standard ESD precautions when installing the strip.
10. Damaged by corrosion will not be honored as a materials defect claim. It is the user’s responsibility to provide suitable protection against corrosive agents such as moisture and condensation and other harmful elements.
|
