Click image to view original image
Power(W) 1.5W-75W
Output Voltage(KV) , 0.5, 0.8, 1, 2, 3, 5, 8, 10, 15, 20, 30, 40, 50,
Wisman's DEL Series of regulated X-ray power supplies
Offer output voltages to 50kV High voltage and filament
Current can be linearly ramped up. The DEL incorporates
Local and remote programming, monitoring, safety interlock, ARC
Short-circuit and overload protection.
TYPICAL APPLICATIONS
Electrophoresis X-ray Inspection Detector Arrays
Capacitor Charging
OPTIONS
NSS No Slow Start
SS(X) Non-Standard Slow Start
LL(X) Extra Length Output Cable
AC Filament
CPC Constant Power
SPECIFICATIONS
Input:
85-265Vac, 47-63Hz
Output:
11models from 1kV, 2.5KV, 3K, 5K, 8KV, 10KV, 15KV, 20KV, 30KV, 40KV to 50kV. Positive or negative polarity outputs.
Voltage Control:
Local: Internal multi-turn potentiometer to set voltage from 0 to full output voltage.
Remote: 0 to +10Vdc proportional from 0 to full output voltage. Accuracy: ± 1%. ZIN: 10Mohm.
Emission Control:
Local: Internal potentiometer to set beam current between 0 and full output.
Remote: 0 to +10Vdc proportional from 0 to full output current.
Accuracy: ± 1%. ZIN: 10Mohm.
Voltage Regulation:
Load: 0.01% of output voltage no load to full load. Line: ± 0.01% for ± 10% change in input voltage.
Current Regulation:
Load: 0.01% of output current from 0 to rated voltage. Line: 0.01% of rated current over specified input range.
Ripple:
0.1% p-p of output voltage.
Temperature Range:
Operating: 0° C to 40 ° C
Storage: -40° C to 80° C
Temperature Coefficient:
0.01% per ° C, voltage or current regulated.
Stability:
0.02% per 8 hours after 1/2 hour warm-up.
Voltage and Current Monitors:
0 to +10Vdc proportional from 0 to rated output.
Dimensions:
0kV to 50kV:
H140mm x W120mm x D240mm.
Connectors:
HV Output Connector: Delrin type connector, recessed.
Cable assembly with mating connector 39.4in (1m).
I/O Connectors: 15 pin mini D-type Phoenix connector for
Power, filament and monitor connections.
Remote Programming:
(P/O 15 pin "D" analog control interface) Permits remote
Adjustment of the output voltage and current via an external
Potentiometer and the internal +10V reference. By adjusting
The potentiometer from minimum to maximum, the desired
Output may be selected.
Remote Monitor:
Test points are made available at J1 for monitoring voltage
And current outputs. The output polarity is positive from
0 to 10V equal to 0 to 100% of the output.
