Click image to view original image
nameplatesmanufacturers.com
3. Separation: The good cast stainless steel plates washed and dried, and then use the transfer film after plating text and images completely stripped down.
4. glue: There are two ways: First, by using the screen printing method, the sticker on the back of the electroformed screen printing of text and images, you can use after drying; the second is the first printed onto transfer paper sticker , the electroformed text and images on the dried paste will transfer film to the film, after the adhesive film is transferred to the compression of text and graphics on the back cast electricity.
Screen printing signs, panel operation should pay attention to what?
Screen printing signs, panel operation should pay attention to what?
1. The ink can not be blown border, over some of the graphics can be, otherwise the ink will go to the border, get dirty.
2. back to Mexico or the whole back or not back to Mexico, can not return to a part of, or otherwise re-printed ink thickness due to inconsistencies, resulting color is also inconsistent.
3. Hand squeegee, scraping angle before not big small, inconsistent angle, otherwise squeeze under a different amount of ink, the line thickness is different.
4. Hand squeegee speed can not unsteadiness or intermediate stop, uniform requirements, to be able to promptly make screen pops up as well.
5. The squeegee pressure is not suddenly suddenly small, and hard to be consistent about scraper.
6. Hand India is the foundation of machine printed and hand-printed with the spiritual experience adjust the machine to an idea.
7. clean version requires a clean, neat, attention to summing up tips. With the ink has been washing machine, and with the recovery of measures to protect the environment, but also to protect the health of workers.
FAQ nameplate production process
Question: What should be using a diamond cutting tool in the production process nameplate pay attention to?
A: 1 tool clamping to be positive, smooth rotation of the workpiece clamping also positive, flat, tight, so as not to damage the tool.
2. Depth of cut to be small, about 0.1mm, to prevent damage due to eating too cutter knife.
3. To turn backward knife, after retracting stop.
Question: How to get twill cutting surface and grid?
A: To selec the size and position of the workpiece positioned to get a good cutter ideal twill, thickness and knife sharp lines concerned. To get the lattice of the workpiece before and after going on the cutter each cutting once.
Question: When pressing Braille signs, inconsistent thickness, how high light cutting?
A: It should be added on a carbide cutter roughing tool cutting leveling at first, then the diamond cutting tool, which also protects the highlight tool is not damaged, hardness alloy tool also plays a balancing role when rotating cutter.
Question: How high light plate production fixed in the machine?
A: In order to combine solid, should be used in high-quality 500 # Nitto double-sided tape. Braille signage or squeeze out the back two legs fixed after perforation.
Question: Are high-gloss surface may Braille signage screen printing?
Answer: Yes. Such signs seen abroad, there is dry again in Braille printed transparent red ink, but also very beautiful.
Question: What highlights cutting new uses?
A: The use of different cutting tools and machine can process a bright line on the plate panel, the bright side and the bright hole. Vertical machine is also useful to make special tooling on the machine table, carving a variety of patterns and designs on the workpiece.
